Chapter 2 General Operation
Controlling the 9102 from a PC
9102 Handheld Spectrum Analyzer Software version 5.31
41
Changing the GPS
display settings
In the MODE > GPS Data menu, use the Coordin. key to toggle between
longitude and latitude display in degrees only (decimal scale) or in
degrees and minutes.
The altitude can be displayed in either meters or feet. In the M
ODE >
GPS Data
menu, use the Altitude key to toggle between meters and
feet.
The speed of the measuring device can be displayed in either kilome-
teres per hour (KPH) or in knots. (KTS). In the M
ODE > GPS Data menu,
use the
Speed key to toggle between KPH and KTS.
Controlling the 9102 from a PC
The 9102 can be used under remote control from a PC. The interfaces
supported for this are the serial interface (RS-232) and the LAN (TCP/
IP). Please refer to section “SCPI Command Reference” on page 257
for more information on remote control.
Returning from remote control to local mode
To gain manual control after using the 9102 under remote control,
press E
SCAPE.
Checking general settings
This section covers information about the unit, setting display bright-
ness, time and date, and configuring the remote control interfaces of
the 9102.
Reading the serial
number
You can find the serial number of your 9102 as follows:
1 Push the M
ODE function key.
To Next Page
Loading...
