Safety Notes
Safety warnings
xx 9102 Handheld Spectrum Analyzer Software version 5.31
Safety warnings
This product is designed for indoor use. As exposure to water can
damage the instrument it has to be protected against moisture when
used outdoors.
WARNING
This is a safety class A equipment in accordance with EN 61326. It
may produce radio interference affecting household equipment; the
user may be forced to execute appropriate measures against radia-
tion.
WARNING
Only use a 50 N-type connector to connect to the RF
IN port of
the 9102. Use of any other connector may result in damage of the
instrument.
WARNING
Do not cover the ventilation slits (at the bottom left-hand corner and
on the top). Covering them may result in serious damage and fire.
WARNING
The maximum input power level at the RF
IN connector is 30 dBm
(1 W). Higher input levels may result in serious damage of the instru-
ment.
WARNING
Operate the instrument within the temperature range from 5°C
(40°F) to 45°C (110°F) only. Operation outside this range will lead to
invalid results.
Safety advice for the battery
Do not crush. Do not heat or incinerate. Do not short-circuit. Do not
dismantle. Do not immerse in any liquid, it may vent or rupture! Do
not charge below 0°C (32°F) nor above 45°C (110°F).
Battery usage
The battery is for use with the 9102 only. Aeroflex does not accept
any liability for damage of the battery or other equipment if the bat-
tery is used with other electric or electronic equipment.
WARNING
The 9162 Insertion Power Sensor may be hot during and after oper-
ation.
WARNING
Do not feed more than +47 dBm into the 9162 Insertion Power Sen-
sor, the device may be destroyed otherwise.
To Next Page
Loading...
