Chapter 2 General Operation
Checking general settings
9102 Handheld Spectrum Analyzer Software version 5.31
45
Enabling and disabling
beeps
Warning and error beeps can be turned off and on in the General
Settings menu:
1 Push the M
ODE function key.
2 Select
System > Settings.
The general settings display appears, showing the current setting
for beeps (on or off).
3 Press the
Beep softkey several times until the desired setting is
highlighted (on or off).
The beep input field shows the current setting.
Assigning a device name
to the instrument
A device name for the 9102 can be useful if you have several units of
the 9102 Handheld Spectrum Analyzer. They can be identified if you
choose different names for them. The name also appears on traces
transferred to the PC with the 9100 Data Exchange Software.
You can enter a new name as follows:
1 Push the M
ODE function key.
2 Select
System > General Settings.
The general settings display appears, showing the current device
name.
3 Press the
Device Name softkey.
The device name input field is active so you can overwrite the
current name.
4 Enter a new name (max. 11 characters; see section “Filling in a text
input field” on page 28 to learn how to do this) and close the entry
field by pressing E
NTER.
The new name is displayed in the device name field.
NOTE
The display setting for adjusting the brightness is not affected by a
press on the P
RESET function key but by a push on the Back to
Defaults
softkey.
NOTE
This parameter is not affected by a press on the P
RESET function key
but by a push on the
Back to Defaults softkey.
NOTE
This parameter is not affected by a press on the P
RESET function key
but by a push on the
Back to Defaults softkey.
To Next Page
Loading...
