Chapter 9 Reflection Operation
Selecting the measurement mode
9102 Handheld Spectrum Analyzer Software version 5.31
145
Selecting the measurement mode
To select the reflection mode, proceed as follows:
1 Push the M
ODE function key.
The Mode menu appears.
2 Select
VSWR/Tracking ... > Reflection.
The reflection main menu appears.
Preparative steps
Before starting the measurement the following preparative steps are
necessary:
– Connecting the 9160 VSWR/DTF Bridge
For details on this procedure refer to “Connecting the 9160 VSWR/
DTF Bridge” on page 140.
– Selecting the desired frequency band
– Calibration
The next section section shows how to change the frequency settings
on the 9102. This section is followed by a description of the calibration
process.
NOTE
This mode is available for selection, if the 9130 VSWR/DTF Reflec-
tion Measurement Option is installed and acitivated on your instru-
ment.
To Next Page
