Aeroflex 9102 - Changing the IP Port Used by the 9102

Chapter 2 General Operation
Checking general settings
9102 Handheld Spectrum Analyzer Software version 5.31
49
1 Push the MODE function key.
2 Select
System > I/O Config
The TCP/IP Config menu is displayed (see Figure 13), showing the
current TCP/IP settings.
3 Select
System > I/O Config.
The port configuration display appears, showing the current TCP/IP
settings.
4 To change the IP address of the 9102, press the
Host IP softkey.
The address field is highlighted.
5 Overwrite the entire IP address or select a field with the L
EFT/
R
IGHT cursor keys, enter a new IP address and press ENTER.
6 Reboot the 9102 (that means, switch it off and on again) for the
new settings to work.
Changing the IP port
used by the 9102
When the 9102 Handheld Spectrum Analyzer is to be controlled
remotely from a PC, the PC must address the remote control applica-
tion within the 9102 with an IP port number. The 9102 uses a default of
49200 which can be changed easily as follows:
1 Push the M
ODE function key.
2 Select
System > I/O Config
The TCP/IP Config menu is displayed, showing the current TCP/IP
settings.
3 To change the IP port of the 9102, push the
Port softkey.
The address field is highlighted.
4 Overwrite the entire IP address or select a field with the L
EFT/
R
IGHT cursor keys, enter a new IP address and press ENTER.
5 Reboot the 9102 (that means, switch it off and on again) for the
new settings to work.
The
Back to Default softkey resets the parameter to its default value.