Aeroflex 9102 - Predefined Channel Power Communication Systems; Preinstalled Systems on the 9102

Appendix B Predefined Settings
Predefined channel power communication systems
9102 Handheld Spectrum Analyzer Software version 5.31
359
Predefined channel power communication systems
Measurements in channel power mode imply that a communication
system with predefined channel numbers and associated frequencies
has been defined. The 9102 comes with a few systems preinstalled.
More systems are available for download to the 9102 in the 9100 Data
Exchange Software. The following two sections provide you with an
overview on the communication systems preinstalled on your 9102 as
well as on the systems available in the 9100 Data Exchange Software.
Preinstalled systems on
the 9102
The following table lists all communication systems preinstalled as a
default on your 9102. For details on working with the preinstalled
systems refer to “Working with communication systems and frequency
settings” on page 87.
Table 2 Default preinstalled channel power systems
System
name
Meaning
Frequency
range
Channel
numbers
(n)
Center frequencies
(f
c
)
Channel
width
DECT 1880 to 1900
MHz
0 to 9 f
c
= 1897.344 -
n*1.728
1728 kHz
PGSM900-
DL
Primary
GSM Down-
link
935 to 960
MHz
1 to 124 f
c
= 935 + 0.2*n 200 kHz
RGSM900-
DL
Railways
GSM Down-
link
921 to 960 MHz 955 to
1023
f
c
= 935 + 0.2*(n-
1024)
200 kHz
PCN1800-
DL
GSM 1800
Downlink
1805 to 1880
MHz
512 t o
885
f
c
= 1805.2 + 0.2*(n-
512 )
200 kHz
PCS1900-
DL
GSM 1900
Downlink
1930 to 1990
MHz
512 t o
810
f
c
= 1930.2 + 0.2*(n-
512 )
200 kHz
WCDMA-DL UTRA-FDD
Downlink
2110 to 2170
MHz
10562 to
10838
f
c
= n / 5 5 MHz
WCDMA-UL UTRA-FDD
Uplink
1920 to 1980
MHz
9612 to
9888
f
c
= n / 5 5 MHz
WLAN IEEE
802.11b,g
2400 to 2484
MHz
1 to 13 f
c
= 2412 + (n-1)*5 22 MHz