Aeroflex 9102 - Marker Frequency; Marker Level; Max Peak; Next Peak

Chapter 17 Programming Examples
Command examples
9102 Handheld Spectrum Analyzer Software version 5.31
345
Max Peak CALCulate:MARKer:MAXPeak Sets the marker to the maximum peak
Examples:
Long format:
CALCULATE:MARKER:MAXPEAK Marker set to max. peak
Short format:
CALC:MARK:MAXP Marker set to max. peak
Next Peak CALCulate:MARKer:NPEak Sets the marker to the next highest peak
Examples:
Long format:
CALCULATE:MARKER:NPEAK Marker set to the next peak
Short format:
CALC:MARK:NPE Marker set to the next peak
Marker level CALCulate:MARKer:<x>:Y?Reads the level at the actual marker position
<x> selects the trace (A to D)
Examples:
Long format:
CALCULATE:MARKER:B:Y? Marker B level requested
Short format:
CALC:MARK:A:Y? Marker A level requested
Marker frequency CALCulate:MARKer:<x>:X? Reads the actual marker frequency
<x> selects the trace (A to D)
Examples:
Long format:
CALCULATE:MARKER:B:X? Marker B frequency requested
NOTE
A marker must be activated first using the following command:
CALC:MARKer:<x>[:STATE] {NORMal|DELTa|NOISe}.
NOTE
A marker must be activated first using the following command:
CALC:MARKer:<x>[:STATE] {NORMal|DELTa|NOISe}.