Contents
InfiniiVision 7000B Series Oscilloscopes User’s Guide 9
3 Displaying Waveforms 61
Using the Horizontal Controls 62
To adjust the horizontal (time/div) scale 63
To adjust the horizontal delay (position) 63
Panning and Zooming Single or Stopped Acquisitions 64
To change the horizontal time mode (Normal, XY, or Roll) 65
To display the zoomed time base 71
To change the horizontal scale knob’s coarse/fine adjustment setting 73
To position the time reference (left, center, right) 74
To navigate the time base 74
Using the Vertical Controls 77
To turn waveforms on or off (channel or math) 78
To adjust the vertical scale 78
To adjust the vertical position 78
To specify channel coupling 79
To specify channel input impedance 79
To specify bandwidth limiting 80
To change the vertical scale knob’s coarse/fine adjustment setting 81
To invert a waveform 81
Setting Analog Channel Probe Options 82
To specify the channel units 82
To specify the probe attenuation 82
To specify the probe skew 83
To calibrate a probe 83
Changing the Display Settings 84
To adjust waveform intensity 84
To set or clear infinite persistence 85
To clear the display 86
To adjust the grid brightness 86
To display waveforms as vectors or dots 87
To freeze the display 87
To Next Page
Loading...
Need help?
General
