Version 7.2 1185 Mediant 800B Gateway & E-SBC
User's Manual 72. Configuration Parameters Reference
Parameter Description
configure voip > gateway voice-mail-
setting > smdi-timeout-[msec]
[SMDITimeOut]
Call Status message before or after a Setup message is
received. The parameter synchronizes the SMDI and analog
CAS interfaces.
If the timeout expires and only an SMDI message is
received, the SMDI message is dropped. If the timeout
expires and only a Setup message is received, the call is
established.
The valid range is 0 to 10000 (i.e., 10 seconds). The default
is 2000.
Message Waiting Indication (MWI) Parameters
MWI Off Digit Pattern
configure voip > gateway voice-mail-
setting > mwi-off-dig-ptrn
[MWIOffCode]
Defines the digit code used by the device to notify the PBX
that there are no messages waiting for a specific extension.
This code is added as prefix to the dialed number.
The valid range is a 25-character string.
MWI On Digit Pattern
configure voip > gateway voice-mail-
setting > mwi-on-dig-ptrn
[MWIOnCode]
Defines the digit code used by the device to notify the PBX
of messages waiting for a specific extension. This code is
added as prefix to the dialed number.
The valid range is a 25-character string.
MWI Suffix Pattern
configure voip > gateway voice-mail-
setting > mwi-suffix-pattern
[MWISuffixCode]
Defines the digit code used by the device as a suffix for
'MWI On
Digit Pattern' and 'MWI Off Digit Pattern'. This suffix
is added to the generated DTMF string after the extension
number.
The valid range is a 25-character string.
MWI Source Number
configure voip > gateway voice-mail-
setting > mwi-source-number
[MWISourceNumber]
Defines the calling party's phone number used in the Q.931
MWI Setup message to PSTN. If not configured, the
channel's phone number is used as the calling number.
configure voip > gateway dtmf-supp-
service supp-service-settings > mwi-
subs-ipgrpid
[MWISubscribeIPGroupID]
Defines the IP Group ID used when subscribing to an MWI
server. The 'The SIP Group Name' field value of the IP
Groups table is used as the Request-URI host name in the
outgoing MWI SIP SUBSCRIBE message. The request is
sent to the IP address defined for the Proxy Set that is
associated with the IP Group. The Proxy Set's capabilities
such as proxy redundancy and load balancing are also
applied to the message.
For example, if the 'SIP Group Name' field of the IP Group is
set to "company.com", the device sends the following
SUBSCRIBE message:
SUBSCRIBE sip:company.com...
Instead of:
SUBSCRIBE sip:10.33.10.10...
Note: If the parameter is not configured, the MWI
SUBSCRIBE message is sent to the MWI server as defined
by the MWIServerIP parameter.
[NotificationIPGroupID] Defines the IP Group ID to which the device sends SIP
NOTIFY MWI messages.
Note:
To Next Page
Loading...
