User's Manual 1186 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
This is used for MWI Interrogation. For more information
on the interworking of QSIG MWI to IP, see Message
Waiting Indication on page
600.
To determine the handling method of MWI Interrogation
messages, use the
TrunkGroupSettings_MWIInterrogationType, parameter
(in the Trunk Group Settings table).
MWI Notification Timeout
configure voip > gateway
dtmf-supp-service supp-
service-settings > mwi-ntf-
timeout
[MWINotificationTimeout]
Global parameter defining the maximum duration (timeout)
that a message waiting indication (MWI) is displayed on
endpoint equipment (phones' LED, screen notification or
voice tone).
You can also configure the feature for specific calls, using
Tel Profiles (TelProfile_MWINotificationTimeout). For a
detailed description of the parameter or for configuring the
feature in the Tel Profiles table, see Configuring Tel Profiles
on page 473.
Note:
The parameter is applicable only to FXS interfaces.
If the feature is configured for a specific Tel Profile, the
settings of the global parameter is ignored for calls
associated with the Tel Profile.
configure voip > gateway dtmf-supp-
service supp-service-settings > mwi-
qsig-party-num
[MWIQsigMsgCentreldIDPartyNumber]
Defines the Message Centred ID party number used for
QSIG MWI messages. If not configured (default), the
parameter is not included in MWI (activate and deactivate)
QSIG messages.
The valid value is a string.
Digit Patterns The following digit pattern parameters apply only to voice mail applications that use
the DTMF communication method. For available pattern syntaxes, refer to the CPE Configuration
Guide for Voice Mail.
Forward on Busy Digit Pattern
(Internal)
configure voip > gateway voice-mail-
setting > fwd-bsy-dig-ptrn-int
[DigitPatternForwardOnBusy]
Defines the digit pattern used by the PBX to indicate 'call
forward on busy' when the original call is received from an
internal extension.
The valid range is a 120-character string.
Forward on No Answer Digit Pattern
(Internal)
configure voip > gateway voice-mail-
setting > fwd-no-ans-dig-pat-int
[DigitPatternForwardOnNoAnswer]
Defines the digit pattern used by the PBX to indicate 'call
forward on no answer' when the original call is received from
an internal extension.
The valid range is a 120-character string.
Forward on Do Not Disturb Digit
Pattern (Internal)
configure voip > gateway voice-mail-
setting > fwd-dnd-dig-ptrn-int
[DigitPatternForwardOnDND]
Defines the digit pattern used by the PBX to indicate 'call
forward on do not disturb' when the original call is received
from an internal extension.
The valid range is a 120-character string.
Forward on No Reason Digit Pattern
(Internal)
configure voip > gateway voice-mail-
setting > fwd-no-rsn-dig-ptrn-int
[DigitPatternForwardNoReason]
Defines the digit pattern used by the PBX to indicate 'call
forward with no reason' when the original call is received
from an internal extension.
The valid range is a 120-character string.
To Next Page
Loading...
