AudioCodes Mediant 800B - Page 1232

User's Manual 1232 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
no Channel-Id has been specified in the establishment
request. This is useful for improving required compatibility
with switches. On BRI lines, the Channel-Id IE indicates
‘any channel’. On PRI lines it indicates an unused channel
ID, preferred only.
 [512] USE A LAW = The device sends G.711 A-Law in
outgoing voice calls. When disabled, the device sends the
default G.711-Law in outgoing voice calls.
Note: The option is applicable only to the E10 variant (T1
ISDN).
 [1024] = Numbering plan/type for T1 IP-to-Tel calling
numbers are defined according to the manipulation tables
or according to the RPID header (default). Otherwise, the
plan/type for T1 calls are set according to the length of the
calling number.
Note: The option is applicable only to T1 ISDN.
 [2048] = The device accepts any IA5 character in the
called_nb and calling_nb strings and sends any IA5
character in the called_nb, and is not restricted to extended
digits only (i.e., 0-9,*,#).
 [16384] DLCI REVERSED OPTION = Behavior bit used in
the
IUA interface groups to indicate that the reversed format
of the DLCI field must be used.
Note: When using the ini file to configure the device to support
several ISDNOutCallsBehavior features, add the individual
feature values. For example, to support both [2] and [16]
features, set ISDNOutCallsBehavior = 18 (i.e., 2 + 16).
[ISDNOutCallsBehavior_x] Same as the description for parameter ISDNOutCallsBehavior,
but for a specific trunk ID.
ISDN NS Behaviour 2
configure voip > interface e1-t1|bri >
isdn-bits-ns-extension-behavior
[ISDNNSBehaviour2]
Bit-field to determine several behavior options that influence
the behavior of the Q.931 protocol.
 [8] NS BEHAVIOUR2 ANY UUI = Any User to User
Information Element (UUIE) is accepted for any protocol
discriminator. This is useful for interoperability with non-
standard switches.
 [16] NS BEHAVIOUR2 DISPLAY = The Display IE is
accepted even if it is not defined in the QSIG ISDN protocol
standard. This is applicable only when configuration is QSI.
 [64] NS BEHAVIOUR2 F
AC REJECT = When this bit is set,
the device answers with a Facility IE message with the
Reject component on receipt of Facility IE with
unknown/invalid Invoke component. This bit is implemented
in QSIG and ETSI variants.