AudioCodes Mediant 800B - Page 231

Version 7.2 231 Mediant 800B Gateway & E-SBC
User's Manual 15. Services
Parameter Description
Boot File Name
boot-file-name
[DhcpServer_BootFileName]
Defines the name of the boot file image for the DHCP client.
The boot file stores the boot image for the client. The boot
image is typically the operating system the client uses to load
(downloaded from a boot server). The value is sent in DHCP
Option 67 (Bootfile Name). To define the server storing the file,
use the 'TFTP Server' parameter (see above).
The valid value is a string of up to 256 characters. By default,
no value is defined.
The name can also include the following case-sensitive
placeholder strings that are replaced with actual values if the
'Expand Boot-file Name' parameter is set to Yes:
 <MAC>: Replaced by the MAC address of the client (e.g.,
boot_<MAC>.ini). The MAC address is obtained in the
client's DHCP request.
 <IP>: Replaced by the IP address assigned by the DHCP
server to the client.
Expand Boot-File Name
expand-boot-file-name
[DhcpServer_ExpandBootfileName]
Enables the use of the placeholders in the boot file name,
defined in the 'Boot file name' parameter.
 [0] No
 [1] Yes (default)
Router
Override Router
override-router-address
[DhcpServer_OverrideRouter]
Defines the IP address (IPv4 in dotted-decimal notation) of the
default router that the DHCP server assigns the DHCP client.
The value is sent in DHCP Option 3 (Router).
The default value is 0.0.0.0. If not specified (empty or “0.0.0.0”),
the IP address of the default gateway configured in the IP
Interfaces table for the IP network interface that you associated
with the DHCP server (see the 'Interface Name' parameter
above) is used.
SIP
SIP Server
sip-server
[DhcpServer_SipServer]
Defines the IP address or DNS name of the SIP server that the
DHCP server assigns the DHCP client. The client uses this SIP
server for its outbound SIP requests. The value is sent in DHCP
Option 120 (SIP Server). After defining the parameter, use the
'SIP server type' parameter (see below) to define the type of
address (FQDN or IP address).
The valid value is a string of up to 256 characters. The default is
0.0.0.0.
SIP Server Type
sip-server-type
[DhcpServer_SipServerType]
Defines the type of SIP server address. The actual address is
defined in the 'SIP server' parameter (see above). Encoding is
done per SIP Server Type, as defined in RFC 3361.
 [0] DNS names = (Default) The 'SIP server' parameter is
configured with an FQDN of the SIP server.
 [1] IP address = The 'SIP server' parameter configured with
an IP address of the SIP server.