Version 7.2 259 Mediant 800B Gateway & E-SBC
User's Manual 15. Services
2. Click New; the following dialog box appears:
Figure 15-22: LDAP Servers Table - Add Dialog Box
3. Configure an LDAP server according to the parameters described in the table below.
4. Click Apply.
Table 15-9: LDAP Servers Table Parameter Descriptions
Parameter Description
General
Index
[LdapConfiguration_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
LDAP Servers Group
server-group
[LdapConfiguration_Group]
Assigns the LDAP server to an LDAP Server Group, configured in
the LDAP Server Groups table (see 'Configuring LDAP Server
Groups' on page 256).
Note:
The parameter is mandatory and must be set before
configuring the other parameters in the table.
Up to two LDAP servers can be assigned to the same LDAP
Server Group.
LDAP Network Interface
interface-type
[LdapConfiguration_Interface]
Assigns one of the device's IP network interfaces through which
communication with the LDAP server is done.
By default, no value is defined and the device uses the OAMP
network interface, configured in the IP Interfaces table.
To configure IP network interfaces, see 'Configuring IP Network
Interfaces' on page 146.
Note: The parameter is mandatory.
To Next Page
Loading...
