AudioCodes Mediant 800B - Page 260

User's Manual 260 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Use TLS
use-tls
[LdapConfiguration_useTLS]
Enables the device to encrypt the username and password (for
Control and Management related queries) using TLS when
sending them to the LDAP server.
 [0] No = (Default) Username and password are sent in clear-
text format.

[1]
Yes
TLS Context
tls-context
[LdapConfiguration_ContextNam
e]
Assigns a TLS Context for the connection with the LDAP server.
By default, no value is defined and the device uses the default
TLS Context (ID 0).
To configure TLS Contexts, see 'Configuring TLS Certificate
Contexts' on page 113.
Note: The parameter is applicable only if the 'Use TLS' parameter
is configured to Yes.
Connection
LDAP Server IP
server-ip
[LdapConfiguration_LdapConfSe
rverIp]
Defines the IP address of the LDAP server (in dotted-decimal
notation, e.g., 192.10.1.255).
By default, no IP address is defined.
Note:
 The parameter is mandatory.
 If you want to use an FQDN for the LDAP server, leave the
parameter undefined and configure the FQDN in the 'LDAP
Server Domain Name' parameter (see below).
LDAP Server Port
server-port
[LdapConfiguration_LdapConfSe
rverPort]
Defines the port number of the LDAP server.
The valid value range is 0 to 65535. The default port number is
389.
LDAP Server Max Respond
Time
max-respond-time
[LdapConfiguration_LdapConfSe
rverMaxRespondTime]
Defines the duration (in msec) that the device waits for LDAP
server responses.
The valid value range is 0 to 86400. The default is 3000.
Note: If the response time expires, you can configure the device
to use the Local Users table for authenticating the user. For more
information, see 'Configuring Local Database for Management
User Authentication' on page 271.
LDAP Server Domain Name
domain-name
[LdapConfiguration_LdapConfSe
rverDomainName]
Defines the domain name (FQDN) of the LDAP server. The device
tries to connect to the LDAP server according to the IP address
listed in the received DNS query. If there is no connection to the
LDAP server or the connection to the LDAP server fails, the
device tries to connect to the LDAP server with the next IP
address in the DNS query list.
Note: If the 'LDAP Server IP' parameter is configured, the 'LDAP
Server Domain Name' parameter is ignored. Thus, if you want to
use an FQDN, leave the 'LDAP Server IP' parameter undefined.