AudioCodes Mediant 800B - Page 290

User's Manual 290 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
3. Configure a remote Web service according to the parameters described in the table below.
4. Click Apply, and then save your settings to flash memory.
Table 15-19: Remote Web Services Table Parameter Descriptions
Parameter Description
General
Index
[HTTPRemoteServices_Index]
Defines an index number for the new table row.
Note:
 Each row must be configured with a unique index.
 The parameter is mandatory.
Name
rest-name
[HTTPRemoteServices_Name]
Defines a descriptive name, which is used when associating the row in
other tables.
The valid value is a string of up to 40 characters.
Note:
 Each row must be configured with a unique name.
 The parameter is mandatory.
Type
rest-message-type
[HTTPRemoteServices_HTTPT
ype]
Defines the type of service provided by the HTTP remote host:
 [0] Routing (default) = Routing service (also includes Call Status and
Topology Status).
 [1] Call Status = Call status service.
 [2] Topology Status = Topology status service (e.g., change in
configuration).
 [3] Capture = Recording of signaling and RTP packets, which can be
sent to a remote host, for example, to a Syslog server or AudioCodes
SEM.
 [5] QoS = QoS-based call routing. For more information, see
Configuring QoS-Based Routing by Routing Server on page 297.
Note:
 You can configure only one remote Web service for each of the
following service types: Routing, Call Status, Topology Status, and
QoS.
 For the Topology Status option to be functional, you must enable the
functionality (see 'Enabling Topology Status Services' on page 294).
 The Routing option also includes the Call Status and Topology Status
services.
 If you do no configure the parameter to QoS, the device sends QoS
reports to the Topology server.
 Currently, the Capture option is not supported.
Path
rest-path
[HTTPRemoteServices_Path]
Defines the path (prefix) to the REST APIs.
The valid value is a string of up to 80 characters. The default is "api".
Status
http-service-state
[HTTPRemoteServices_Service
Status]
(Read-only) Displays the status of the host associated with the Web
service.
 "Connected": At least one of the hosts is connected.
 "Disconnected": All hosts are disconnected.
 "Not In Service": Configuration of the service is invalid.
Connection