AudioCodes Mediant 800B - Page 329

Version 7.2 329 Mediant 800B Gateway & E-SBC
User's Manual 16. Quality of Experience
Note: For your convenience, the device provides pre-configured Quality of Experience
Profiles. One of these pre-configured profiles is the default Quality of Experience Profile,
which is used if you do not configure a Quality of Experience Profile.
The following procedure describes how to configure Quality of Experience Profiles through the
Web interface. You can also configure it through other management platforms:

Quality of Experience Profile table: ini file (QoEProfile) or CLI (configure voip > qoe qoe-
profile)

Quality of Experience Color Rules table: ini file (QOEColorRules) or CLI (configure voip >
qoe qoe-color-rules)
 To configure a QoE Profile:
1. Open the Quality of Experience Profile table (Setup menu > Signaling & Media tab > Media
folder > Quality of Experience > Quality of Experience Profile).
2. Click New; the following dialog box appears:
Figure 16-3: Quality of Experience Profile Table - Dialog Box
3. Configure a QoE Profile according to the parameters described in the table below.
4. Click Apply.
Table 16-2: Quality of Experience Profile Table Parameter Descriptions
Parameter Description
Index
[QOEProfile_Index]
Defines an index number for the new table row.
Note: Each row must be configured with a unique index.
Profile Name
name
[QOEProfile_Name]
Defines a descriptive name, which is used when associating the row
in other tables.
The valid value is a string of up to 20 characters.
Sensitivity Level
sensitivity-level
[QOEProfile_SensitivityLevel]
Defines the pre-configured threshold profile to use.
 [0] User Defined = Need to define thresholds per monitored
parameter in the Quality of Experience Color Rules table.
 [1] Low = Pre-configured low sensitivity thresholds.
 [2] Medium = (Default) Pre-configured medium sensitivity
thresholds.
 [3] High = Pre-configured high sensitivity thresholds. Reporting is
done for small fluctuations in parameter values.
5. In the Quality of Experience Profile table, select the row for which you want to configure QoE