AudioCodes Mediant 800B - Page 360

User's Manual 360 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description

Each SIP Interface must have a unique signaling port (i.e., no two
SIP Interfaces can share the same port - no port overlapping).
TCP Port
tcp-port
[SIPInterface_TCPPort]
Defines the device's listening port for SIP signaling traffic over TCP.
The valid range is 1 to 65534. The default is 5060.
Note:
 The port must be different from ports configured for RTP traffic
(i.e., ports configured for Media Realms). For example, if the RTP
port range is 6000 to 6999, the SIP port can either be less than
6000 or greater than 6999.
 Each SIP Interface must have a unique signaling port (i.e., no two
SIP Interfaces can share the same port - no port overlapping).
TLS Port
tls-port
[SIPInterface_TLSPort]
Defines the device's listening port for SIP signaling traffic over TLS.
The valid range is 1 to 65534. The default is 5061.
Note:
 The port must be different from ports configured for RTP traffic
(i.e., ports configured for Media Realms). For example, if the RTP
port range is 6000 to 6999, the SIP port can either be less than
6000 or greater than 6999.
 Each SIP Interface must have a unique signaling port (i.e., no two
SIP Interfaces can share the same port - no port overlapping).
Additional UDP Ports
additional-udp-ports
[SIPInterface_AdditionalUDP
Ports]
Defines a port range for the device's local, listening and source ports
for SIP signaling traffic over UDP. The parameter is used to assign a
specific local port to each SIP entity (e.g., PBX) communicating with a
common SIP entity (e.g., proxy server). This applies to the device's
local ports on the leg interfacing with the proxy server. In other words,
this SIP Interface is associated with the proxy server.
The valid range is 1,025 to 65535. The range is configured using the
syntax x-y, where x is the starting port and y the ending port of the
range (e.g., 6000-7000). By default, the parameter is not configured.
For more information on configuring specific UDP ports for SIP entities
communicating with a common proxy server, see Configuring Specific
UDP Ports using Tag-based Routing on page 724.
Note:
 The parameter's port range value must not overlap with the UDP
port configured by the 'UDP Port' parameter
(SIPInterface_UDPPort). For example, if the 'UDP Port' parameter
is configured to 5070, you cannot configure the 'Additional UDP
Ports' parameter with a range of 5060-6000.
 The parameter's port range value must not overlap with UDP port
ranges of Media Realms that are configured on the same network
interface. For example, if the RTP port range is 6000-6999, you
must configure the 'Additional UDP Ports' parameter to a range that
is less than 6000 or greater than 6999.
 The maximum number of ports in the range is limited to the
maximum number of IP Groups that can be configured (see
Configuring IP Groups on page 365).
 The parameter is applicable only to the SBC application.