AudioCodes Mediant 800B - Page 359

Version 7.2 359 Mediant 800B Gateway & E-SBC
User's Manual 17. Control Network
Table 17-5: SIP Interfaces table Parameter Descriptions
Parameter Description
SRD
srd-name
[SIPInterface_SRDName]
Assigns an SRD to the SIP Interface.
If only one SRD is configured in the SRDs table, the SRD is assigned
to the SIP Interface by default. If multiple SRDs are configured in the
SRDs table, no value is defined and you must assign an SRD.
To configure SRDs, see 'Configuring SRDs' on page 347.
Note:
 The parameter is mandatory.
 You can assign the same SRD to multiple SIP Interfaces (SBC and
Gateway).
General
Index
[SIPInterface_Index]
Defines an index for the new table row.
Note: Each row must be configured with a unique index.
Name
interface-name
[SIPInterface_InterfaceName
]
Defines a descriptive name, which is used when asso
ciating the row in
other tables.
The valid value is a string of up to 40 characters. By default, if you do
not configure a name, the device automatically assigns the name
"SIPInterface_<row index>" (e.g., "SIPInterface_1" when added to
Index 1).
Topology Location
topology-location
[SIPInterface_TopologyLocat
ion]
Defines the display location of the SIP Interface in the Topology view
in the Web interface.
 [0] Down = (Default) The SIP Interface element is displayed on the
lower border of the view.
 [1] Up = The SIP Interface element is displayed on the upper
border of the view.
For more information on the Topology view, see 'Building and Viewing
SIP Entities in Topology View' on page 388.
Network Interface
network-interface
[SIPInterface_NetworkInterfa
ce]
Assigns a Control-type IP network interface to the SIP Interface.
By default, no value is defined.
To configure network interfaces, see 'Configuring IP Network
Interfaces' on page 146.
Note: The parameter is mandatory.
Application Type
application-type
[SIPInterface_ApplicationTyp
e]
Defines the application for which the SIP Interface is used.
 [0] GW = (Default) Gateway application.

 [2] SBC = SBC application.
UDP Port
udp-port
[SIPInterface_UDPPort]
Defines the device's listening and source port for SIP signaling traffic
over UDP.
The valid range is 1 to 65534. The default is 5060.
Note:
 The port must be different from ports configured for RTP traffic
(i.e., ports configured for Media Realms). For example, if the RTP
port range is 6000 to 6999, the SIP port can either be less than
6000 or greater than 6999.