Version 7.2 375 Mediant 800B Gateway & E-SBC
User's Manual 17. Control Network
Parameter Description
[0] No = (Default) The device creates a new Call-ID value for the
outgoing message.
[1] Yes = The device uses the same Call-ID value received in the
incoming message for the Call-ID in the outgoing message.
Note: When the device sends an INVITE as a result of a REFER/3xx
termination, the device always creates a new Call-ID value and ignores
the parameter's settings.
Dial Plan
sbc-dial-plan-name
[IPGroup_SBCDialPlanNa
me]
Assigns a Dial Plan to the IP Group. The device searches the Dial Plan
for a dial plan rule that matches the source number and if not found, for
a rule that matches the destination number. If a matching dial plan rule
is found, the rule's tag is used in the routing and/or manipulation
processes as source and/or destination tags.
To configure Dial Plans, see Configuring Dial Plans on page 751.
Note: For IP-to-IP Routing rules that are configured for destination
based on tags (i.e., 'Destination Type' parameter configured to
Destination Tag), the parameter is applicable only to the source IP
Group and the device searches the Dial Plan for a dial plan rule that
matches the prefix of the destination number only. For more
information on routing based on destination tags, see Using Dial Plan
Tags for Routing Destinations on page 761.
Tags
tags
[IPGroup_Tags]
Assigns a Dial Plan tag that is used to determine whether the incoming
SIP dialog is sent to this IP Group. The parameter is used when IP-to-IP
Routing rules are configured for destination based on tags (i.e.,
'Destination Type' parameter configured to Destination Tag). For more
information on routing based on destination tags, see Using Dial Plan
Tags for Routing Destinations on page 761.
Call Setup Rules Set ID
call-setup-rules-set-id
[IPGroup_CallSetupRules
SetId]
Assigns a Call Setup Rule Set ID to the IP Group. The device runs the
Call Setup rule immediately before the routing stage (i.e., only after the
classification and manipulation stages).
By default, no value is assigned.
To configure Call Setup Rules, see Configuring Call Setup Rules on
page 404.
Quality of Experience
QoE Profile
qoe-profile
[IPGroup_QOEProfile]
Assigns a Quality of Experience Profile rule.
By default, no value is defined.
To configure Quality of Experience Profiles, see 'Configuring Quality of
Experience Profiles' on page 327.
Bandwidth Profile
bandwidth-profile
[IPGroup_BWProfile]
Assigns a Bandwidth Profile rule.
By default, no value is defined.
To configure Bandwidth Profiles, see 'Configuring Bandwidth Profiles' on
page 332.
Message Manipulation
Inbound Message
Manipulation Set
inbound-mesg-
manipulation-set
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the inbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see Configuring SIP Message
To Next Page
Loading...
