AudioCodes Mediant 800B - Page 376

User's Manual 376 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
[IPGroup_InboundManSet]
Manipulation on page 413.
Note:
 The parameter is applicable only to the SBC application.

The IPGroup_SIPGroupName parameter overrides inbound message
manipulation rules (assigned to the IPGroup_InboundManSet
parameter) that manipulate the host name in Request-URI, To,
and/or From SIP headers. If you want to manipulate the host name
using message manipulation rules in any of these SIP headers, you
must apply your manipulation rule (Manipulation Set ID) to the IP
Group as an Outbound Message Manipulation Set (see the
IPGroup_OutboundManSet parameter), when the IP Group is the
destination of the call.
Outbound Message
Manipulation Set
outbound-mesg-
manipulation-set
[IPGroup_OutboundManS
et]
Assigns a Message Manipulation Set (rule) to the IP Group for SIP
message manipulation on the outbound leg.
By default, no value is defined.
To configure Message Manipulation rules, see 'Configuring SIP
Message Manipulation' on page 413.
Note: If you assign a Message Manipulation Set ID that includes rules
for manipulating the host name in the Request-
URI, To, and/or From SIP
headers, the parameter overrides the IPGroup_SIPGroupName
parameter.
Message Manipulation
User-Defined String 1
msg-man-user-defined-
string1
[IPGroup_MsgManUserDe
f1]
Defines a value for the SIP user part that can be used in Message
Manipulation rules configured in the Message Manipulations table. The
Message Manipulation rule obtains this value from the IP Group, by
using the following syntax:
param.ipg.<src|dst>.user-defined.<0>.
The valid value is a string of up to 30 characters. By default, no value is
defined.
To configure Message Manipulation rules, see 'Configuring SIP
Message Manipulation' on page 413.
Message Manipulation
User-Defined String 2
msg-man-user-defined-
string2
[IPGroup_MsgManUserDe
f2]
Defines a value for the SIP user part that can be used in Message
Manipulation rules configured in the Message Manipulations table. The
Message Manipulation rule obtains this value from the IP Group, by
using the following syntax: param.ipg.<src|dst>.user-defined.<1>.
The valid value is a string of up to 30 characters. By default, no value is
defined.
To configure Message Manipulation rules, see 'Configuring SIP
Message Manipulation' on page 413.
SBC Registration and Authentication
Max. Number of
Registered Users
max-num-of-reg-users
[IPGroup_MaxNumOfReg
Users]
Defines the maximum number of users in this IP Group that can register
with the device.
The default is -1, meaning that no limitation exists for registered users.
Note: The parameter is applicable only to User-type IP Groups.
Registration Mode
registration-mode
[IPGroup_RegistrationMod
e]
Defines the registration mode for the IP Group:
 [0] User Initiates Registration (default)
 [1] SBC Initiates Registration = Used when the device serves as a
client (e.g., with an IP PBX). This functions only with the User Info
file.