Version 7.2 381 Mediant 800B Gateway & E-SBC
User's Manual 17. Control Network
Interface and redundancy features - ini file parameter, ProxySet or CLI command,
configure voip > proxy-set
Proxy Set Address table ("child"): Defines the addresses of the Proxy Set - table ini
file parameter, ProxyIP or CLI command, configure voip > proxy-ip > proxy-set-id
To configure a Proxy Set:
1. Open the Proxy Sets table (Setup menu > Signaling & Media tab > Core Entities
folder >Proxy Sets).
2. Click New; the following dialog box appears:
Figure 17-10: Proxy Sets Table - Add Dialog Box
3. Configure a Proxy Set according to the parameters described in the table below.
4. Click Apply.
5. Select the index row of the Proxy Set that you added, and then click the Proxy
Address link located below the table; the Proxy Address table opens.
6. Click New; the following dialog box appears:
Figure 17-11: Proxy Address Table - Add Dialog Box
7. Configure the address of the Proxy Set according to the parameters described in the
table below.
8. Click Apply.
To Next Page
Loading...
