AudioCodes Mediant 800B - Page 720

User's Manual 720 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
this table). For more information, see 'Configuring SBC
Routing Policy Rules' on page 730.
Destination SIP Interface
dest-sip-interface-name
[IP2IPRouting_DestSIPInterfaceN
ame]
Defines the destination SIP Interface to where the call is sent.
By default, no value is defined.
To configure SIP Interfaces, see 'Configuring SIP Interfaces' on
page 357.
Note:
 The parameter is applicable only if the 'Destination Type'
parameter is configured to any value other than IP Group. If
the 'Destination Type' parameter is configured to IP Group,
the following SIP Interface is used:

Server-type IP Groups: SIP Interface that is assigned to
the Proxy Set associated with the IP Group.

User-type IP Groups: SIP Interface is determined during
user registration with the device.
 For multi-tenancy, if the assigned Routing Policy is not shared
(i.e., the Routing Policy is associated with an Isolated SRD),
the SIP Interface must be one that is associated with the
Routing Policy or with a shared Routing Policy (i.e., the
Routing Policy is associated with one or more Shared SRDs).
If the Routing Policy is shared, the SIP Interface can be one
that is associated with any SRD or Routing Policy (but it's
recommended that it belong to the same SRD/Routing Policy
or to shared SRD/Routing Policy to avoid "bleeding").
Destination Address
dst-address
[IP2IPRouting_DestAddress]
Defines the destination address to where the call is sent. The
address can be an IP address or a domain name (e.g.,
domain.com).
If ENUM-based routing is used (i.e., the 'Destination Type'
parameter is set to ENUM) the parameter defines the IP address
or domain name (FQDN) of the ENUM service, for example,
e164.arpa, e164.customer.net or NRENum.net. The device
sends the ENUM query containing the destination phone number
to an external DNS server, configured in the IP Interfaces table.
The ENUM reply includes a SIP URI (user@host) which is used
as the destination Request-URI in this routing table.
The valid value is a string of up to 50 characters (IP address or
FQDN). By default, no value is defined.
Note:
 The parameter is applicable only if the 'Destination Type'
parameter is set to Dest Address [1] or ENUM [3]; otherwise,
the parameter is ignored.
 When using domain names, enter a DNS server IP address or
alternatively, define these names in the Internal DNS table
(see 'Configuring the Internal SRV Table' on page 171).
 To terminate SIP OPTIONS messages at the device (i.e., to
handle them locally), set the parameter to "internal".
Destination Port
dst-port
[IP2IPRouting_DestPort]
Defines the destination port to where the call is sent.
Destination Transport Type Defines the transport layer type for sending the call:
 [-1] = (Default) Not configured - the transport type is