Version 7.2 721 Mediant 800B Gateway & E-SBC
User's Manual 34. Routing SBC
Parameter Description
[IP2IPRouting_DestTransportTyp
e]
determined by the SIPTransportType global parameter.
[0] UDP
[1] TCP
[2] TLS
IP Group Set
ipgroupset-name
[IP2IPRouting_IPGroupSetName]
Assigns an IP Group Set to the routing rule. The device routes
the call to one of the IP Groups in the IP Group Set according to
the load-balancing policy configured for the IP Group Set. For
more information, see Configuring IP Group Sets on page 734.
Note: The parameter is applicable only if you configure the
'Destination Type' parameter to IP Group Set (above).
Call Setup Rules Set ID
call-setup-rules-set-id
[IP2IPRouting_CallSetupRulesSet
Id]
Assigns a Call Setup Rule Set ID to the routing rule. The device
performs the Call Setup rules of this Set ID if the incoming call
matches the characteristics of this routing rule. The device routes
the call to the destination according to the routing rule's
configured action, only after it has performed the Call Setup
rules.
To configure Call Setup rules, see 'Configuring Call Setup Rules'
on page 426.
group-policy
[IP2IPRouting_GroupPolicy]
Defines whether the routing rule includes call forking.
[0] None = (Default) Call uses only this route (even if Forking
Group members are configured in the rows below it).
[1] Forking = Call uses this route and the routes of Forking
Group members, if configured (in the rows below it).
Note: Each Forking Group can contain up to 20 members. In
other words, up to 20 routing rules can be configured for the
same Forking Group.
Cost Group
cost-group
[IP2IPRouting_CostGroup]
Assigns a Cost Group to the routing rule for determining the cost
of the call.
By default, no value is defined.
To configure Cost Groups, see 'Configuring Cost Groups' on
page 285.
Note:
To implement LCR and its Cost Groups, you must enable
LCR for the Routing Policy assigned to the routing rule (see
'Configuring SBC Routing Policy Rules' on page 730). If LCR
is disabled, the device ignores the parameter.
The Routing Policy also determines whether matched routing
rules that are not assigned Cost Groups are considered as a
higher or lower cost route compared to matching routing rules
that are assigned Cost Groups. For example, if the 'Default
Call Cost' parameter in the Routing Policy is configured to
Lowest Cost, even if the device locates matching routing
rules that are assigned Cost Groups, the first-matched routing
rule without an assigned Cost Group is considered as the
lowest cost route and thus, chosen as the preferred route.
Routing Tag Name
routing-tag-name
[IP2IPRouting_RoutingTagName]
Defines the destination Dial Plan tag, which is used to determine
the destination IP Group.
The default value is "default", meaning that the device uses the
first tag name in the Dial Plan rule that is configured without a
To Next Page
Loading...
