AudioCodes Mediant 800B - Page 748

User's Manual 748 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
Parameter Description
Note: If you need to manipulate calls of many different source URI
user names, you can use tags (see 'Source Tags' parameter below)
instead of this parameter.
Source Host
src-host
[IPOutboundManipulation_Src
Host]
Defines the source SIP URI host name - full name, typically in the
From header.
The default value is the asterisk (*) symbol (i.e., any source host
name).
Source Tags
src-tags
[IPOutboundManipulation_Src
Tags]
Assigns a prefix tag to denote source URI user names
corresponding to the tag configured in the associated Dial Plan.
The valid value is a string of up to 20 characters. The tag is case
insensitive.
To configure prefix tags, see 'Configuring Dial Plans' on page 751.
Note:
 Make sure that you assign the Dial Plan in which you have
configured the prefix tag, to the related IP Group or SRD.
 Instead of using tags and configuring the parameter, you can use
the 'Source Username Prefix' parameter to specify a specific URI
source user or all source users.
Destination Username Prefix
dst-user-name-prefix
[IPOutboundManipulation_Des
tUsernamePrefix]
Defines the prefix of the destination SIP URI user name, typically
located in the Request-URI and To headers.
The default value is the asterisk (*) symbol (i.e., any destination
username prefix). The prefix can be a single digit or a range of
digits. For available notations, see 'Dialing Plan Notation for Routing
and Manipulation' on page 1051.
Note: If you need to manipulate calls of many different destination
URI user names, you can use tags (see 'Destination Tags'
parameter below) instead of this parameter.
Destination Host
dst-host
[IPOutboundManipulation_Des
tHost]
Defines the destination SIP URI host name - full name, typically
located in the Request-URI and To headers.
The default val
ue is the asterisk (*) symbol (i.e., any destination host
name).
Destination Tags
dest-tags
[IPOutboundManipulation_Des
tTags]
Assigns a prefix tag to denote destination URI user names
corresponding to the tag configured in the associated Dial Plan.
The valid value is a string of up to 20 characters. The tag is case
insensitive.
To configure prefix tags, see 'Configuring Dial Plans' on page 751.
Note:
 Make sure that you assign the Dial Plan in which you have
configured the prefix tag, to the related IP Group or SRD.
 Instead of using tags and configuring the parameter, you can use
the 'Destination Username Prefix' parameter to specify a specific
URI destination user or all destinations users.
Calling Name Prefix
calling-name-prefix
[IPOutboundManipulation_Calli
ngNamePrefix]
Defines the prefix of the calling name (caller ID). The calling name
appears in the SIP From header.
The valid value is a string of up to 37 characters. By default, no
prefix is defined.
Message Condition Assigns a Message Condition rule as a matching characteristic.
Message Condition rules define required SIP message formats.