AudioCodes Mediant 800B - Page 749

Version 7.2 749 Mediant 800B Gateway & E-SBC
User's Manual 35. SBC Manipulations
Parameter Description
message-condition-name
[IPOutboundManipulation_Mes
sageConditionName]
To configure Message Condition rules, see 'Configuring Message
Condition Rules' on page 709.
ReRoute IP Group
re-route-ip-group-name
[IPOutboundManipulation_Re
RouteIPGroupName]
Defines the IP Group that initiated (sent) the SIP redirect response
(e.g., 3xx) or REFER message. The parameter is typically used for
re-routing requests (e.g., INVITEs) when interworking is required for
SIP 3xx redirect responses or REFER messages.
The default is Any (i.e., any IP Group).
Note:
 The parameter functions together with the 'Call Trigger'
parameter (see below).
 For more information on interworking of SIP 3xx redirect
responses or REFER messages, see 'Interworking SIP 3xx
Redirect Responses' on page 682 and 'Interworking SIP REFER
Messages' on page 684, respectively.
Action
Manipulated Item
manipulated-uri
[IPOutboundManipulation_IsA
dditionalManipulation]
Defines the element in the SIP message that you want manipulated.
 [0] Source URI = (Default) Manipulates the source SIP Request-
URI user part.
 [1] Destination URI = Manipulates the destination SIP Request-
URI user part.
 [2] Calling Name = Manipulates the calling name in the SIP
message.
Remove From Left
remove-from-left
[IPOutboundManipulation_Re
moveFromLeft]
Defines the number of digits to remove from the left of the
manipulated item prefix. For example, if you enter 3 and the user
name is "john", the new user name is "n".
Remove From Right
remove-from-right
[IPOutboundManipulation_Re
moveFromRight]
Defines the number of digits to remove from the right of the
manipulated item prefix. For example, if you enter 3 and the user
name is "john", the new user name is "j".
Leave From Right
leave-from-right
[IPOutboundManipulation_Lea
veFromRight]
Defines the number of digits to keep from the right of the
manipulated item.
Prefix to Add
prefix-to-add
[IPOutboundManipulation_Pref
ix2Add]
Defines the number or string to add in the front of the manipulated
item. For example, if you enter 'user' and the user name is "john",
the new user name is "userjohn".
If you set the 'Manipulated Item' parameter to Source URI or
Destination URI, you can configure the parameter to a string of up
49 characters. If you set the 'Manipulated Item' parameter to
Calling
Name, you can configure the parameter to a string of up 36
characters.