User's Manual 780 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
a. Open the IP Profiles table (see 'Configuring IP Profiles' on page 436).
b. Do the following:
♦ From the 'ICE Mode' drop-down list (IPProfile_SBCIceMode), select Lite to
enable ICE.
♦ From the 'RTCP Mux' drop-down list (IPProfile_SBCRTCPMux), select
Supported to enable RTCP multiplexing.
♦ From the 'RTCP Feedback' drop-down list (IPProfile_SBCRTCPFeedback),
select Feedback On to enable RTCP feedback.
Figure 38-8: Configuring WebRTC-related Parameters for IP Profile
c. Click Apply.
5. Configure an IP Group for the WebRTC clients:
a. Open the IP Groups table (see 'Configuring IP Groups' on page 365).
b. Do the following:
♦ From the 'Type' drop-down list, select User.
♦ From the 'IP Profile' drop-down list, select the IP Profile that you configured
for the WebRTC clients in Step 3 (e.g., "WebRTC").
♦ From the 'DTLS Context' drop-down list, select the TLS Context that you
configured in Step 1. For more information on DTLS, see 'SRTP using DTLS
Protocol' on page 224.
Figure 38-9: Configuring IP Group for WebRTC Clients
6. Configure IP-to-IP routing rules to route calls between the WebRTC clients and the
enterprise:
To Next Page
Loading...
