User's Manual 870 Document #: LTRT-10632
Mediant 800B Gateway & E-SBC
cmp file:
copy firmware from <URL>
ini or Auxiliary file:
copy <ini file or auxiliary file> from <URL>
CLI script file:
copy cli-script from <URL>
HA devices:
• Hitless Software Upgrade:
# copy firmware from <URL and file name>
• Non-Hitless Software Upgrade:
# copy firmware from <URL and file name> non-hitless
If you load the firmware file through CLI, when you initiate the copy command a message is
displayed in the console showing the load progress. If other management users are
connected to the device through CLI, the message also appears in their CLI sessions,
preventing them from performing further actions on the device and disrupting the upload
process. For more information, refer to the CLI Reference Guide.
To upgrade the device using the Software Upgrade wizard:
1. Make sure that you have installed a License Key that is compatible with the software
version to be installed (see 'License Key' on page 857).
2. It is recommended to enable the Graceful Lock feature (see 'Locking and Unlocking
the Device' on page 823). The wizard resets the device at the end of the upgrade
process, thereby causing current calls to be untimely terminated. To minimize traffic
disruption, the Graceful Lock feature prevents the establishment of new calls.
3. It is recommended to backup the device's configuration to your computer. If an
upgrade failure occurs, you can restore your configuration by uploading the backup file
to the device. For more information, see 'Configuration File' on page 875.
4. Open the Software Upgrade wizard:
• Toolbar: From the Actions drop-down menu, choose Software Upgrade.
• Navigation tree: Setup menu > Administration tab > Maintenance folder >
Software Upgrade.
Figure 49-1: Starting Software Upgrade Wizard
5. Click Start Software Upgrade; the wizard starts, prompting you to load a .cmp file:
To Next Page
Loading...
