13. Projector Control
Image 13-60
IR control
13.7 DMX
Overview
• DMX address
• DMX universe
• DMX mode
•Art-NetDMX
• Front XLR output voltage control
•Monitor
About the ways to control the projector via DMX
With a standard DMX cable equipped with XLR connector DMX signals can be connected to the DMX In port on the communicator
interface. The DMX out can be used to create a chain of DMX devices. One universe can control up to 512 channels.
If you are using a DMX console and other automated lighting products compatible with Art-Net, the Ethernet network can serve as
the link for DMX control. All DMX controls can be sent over the Ethernet cable. Multiple universes are possible.
13.7.1 DMX address
What should be done ?
Before a projector can execute DMX commands, a unique address, called DMX address, should be given to the projector. This
address can vary from 1 to 512.
How to set the DMX address
1. Press Menu to activate the menus and select Pro jector Control → DMX → Address. (image 13-61, image 13-62, image 13-63)
2. Press ENTER to select. (image 13-64)
3. Use the ▲ or ▼ key to change the selected character.
Use the ◄ or ► key to select another character.
Note: Digits can be entered with the digit keys on the remote control or the local keypad. W hen a digit is entered in that way,
the next character will be s elected automatically.
Image 13-61
Main menu, projector control
Image 13-62
Projector control, DMX
180 R5905158 HDF W SERIES 10/07/2012
To Next Page
Loading...
Need help?
General
