13. Projector Control
Image 13-84
DMX overview list
13.8 Buttons
Overview
• Standby button
• Shortcut keys
13.8.1 Standby button
What can be done ?
When going to standby by pressing the standby button, the following can happen:
• Only lamp will be switched off
• Lamp will be switched off and projector electronics will be powered down after an after cool period (ECO standby)
In ECO standby only the microcontroller, communication interface and local (or remote) control are operational. All other electronics
are powered down.
How to set
1. Press Menu to activate the menus and select P rojector Control → Buttons → Standby. (image 13-85, image 13-86, image 13-87)
2. Press ENTER to toggle between [Lamp only] and [Lamp and P ower].
Lamp only : only lamp will be switched off when Standby is pressed. Other electronics remain powered.
Lamp and Power : lamp will be switched off and projector will be powered down.
186
R5905158 HDF W SERIES 10/07/2012
To Next Page
Loading...
Need help?
General
