5. Getting started
5. GETTING STARTED
Overview
• RCU & Local keypad
• Terminology overview
• Power on projector
• Switching to standby
• Power off projector
• Status LEDs
• Using the RCU
• Projector Address
• Source selection
• Alignment of a table mount HDF W series projector
• Alignment of a ceiling mount HDF W series projector
5.1 RCU & Local keypad
How controlling the projector ?
The projector can be controlled by the local keypad or by the remote control unit.
Location of the local keypad ?
The local keypad is located on the input side of the projector.
Remote control functions.
This remote control includes a battery powered infrared (IR) transmitter that allows the user to control the projector remotely. This
remote control is used for source selection, control, adaptation and set up.
Other functions of the remote control are :
• switching between stand by and operational mode.
• switching to "pause" (blanked picture, full power for immediate restarting)
• direct access to all connected sources.
5.2 Terminology overview
Overview
The following table gives an overview of the different functionality of the keys.
R5905158 HDF W SERIES 10/07/2012
45
To Next Page
Loading...
Need help?
General
