8. Input
8.5.2 Background Logo
What can be done ?
A logo can be switched on or off.
When logo is switched on and a logo is available, that logo will be displayed when no signal is available for the main window an no
signal available for the PiP window in case PiP is On.
How to activate logo
1. Press Menu to activate the menus and select Input → No S ignal. → Lo go.
2. Press ENTER to toggle between [O n] or [Off]. (image 8-20, image 8-21, image 8-22)
Image 8-20
Main window
Image 8-21
Input, no signal
Image 8-22
No signal, logo
A dedicated logo can be loaded via Projector Toolset with a HDF W series plug-in installed.
8.5.3 Shutdown settings
How to change the settings
1. Press Menu to activate the menus and select Input → No Signal. → Shutdown. (image 8-23, image 8-24, image 8-25)
2. Press ENTER to toggle between [On ] and [Off].
[On] : projector goes in shutdown after a certain retarding time.
[Off] : projector does not go in shutdown.
R5905158 HDF W SERIES 10/07/2012
75