"Changing the Network Transmission Speed or Transfer Mode"
"Setting the Spooling Function "
"Specifying the Setting for Startup Waiting Time"
Network Settings for the Printer (TCP/IP)
"Setting the IP Address (IP v. 4)"
"Configuring the Protocol Settings"
"Setting IP v. 6"
"Configuring a Computer that Performs Printing"
Network Settings for the Printer (SMB)
"Configuring the Protocol Settings"
"Configuring a Computer that Performs Printing"
IMPORTANT
About SMB printing
You can use SMB printing only when an SD card is installed.
NOTE
To manage the printer effectively
By performing the above tasks, computers on a network can be connected to the printer directly.
When using a TCP/IP protocol, you can manage the printer effectively by specifying Windows on the network as the print
server.
For details on the procedure for configuring the print server, see "Printer Driver Installation Guide."
For details on the procedure for viewing "Printer Driver Installation Guide", see "Installation."
About NetBEUI
This printer does not support NetBEUI.
㻟㻠㻢㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
