Canon LBP6780x - Page 580

(2-Sided)]:
-5.0 to
0.0 to
+5.0 (mm)
[Recovery Printing] [Off], [On]
Specifies whether to print the partially printed page when the printer stops
printing due to a paper jam or an error occurring.
[Check Paper Size] [Off], [On]
Specifies whether the printer should stop printing, displaying the message
<Check paper size.> or continue printing when [MP Tray Paper Size],
[Drawer 1 Size], [Drawer 2 Size], [Drawer 3 Size] is set to [Mixed Sizes].
[Substitute Size] [Off], [On]
When the paper of the target size is not loaded in the printer, the printer
prints on paper of the following sizes.
Size of the Paper to Be Printed
Printer Driver Setting
Letter ĺ A4
A4 ĺ Letter
[Special Print Mode
A]
[Off], [Mode
1], [Mode 2],
[Mode 3],
[Mode 4]
Depending on the paper type or the operating environment, vertical streaks
may appear on the printed paper. In this case, change the setting for this
option. Improving effectiveness for vertical streaks increases in the following
order.
[Off] (Effectiveness: low)
Ļ
[Mode 1]
Ļ
[Mode 2]
Ļ
[Mode 3]
Ļ
[Mode 4] (Effectiveness: high)
Even if you do not change the setting due to change in paper type or
operating environment, this may also avoid vertical streaks appearing on the
printed paper. As improving effectiveness increases, print density decreases.
This may also make outlines appear to be blurred or slightly jagged.
[SD Card Maintenance]
*
[Format] - Delete the contents of the SD card.
[Special Print Mode]
[Curl Correction]
[Multi-Purpose
Tray]: [Off],
[On]
[Drawer 1]:
[Off], [On]
[Drawer 2]
*
:
[Off], [On]
[Drawer 3]
*
:
[Off], [On]
When printed paper curls, set this item to [On].
When setting this item to [On], make sure to set the output slot to
the output tray.
[Plain L Speed
Prior.]
[Off], [On]
Specifies whether to reduce the waiting time until start of printing when the
paper type is set to [Plain L].
[Special Print Adj.
C]
[Off], [On]
Depending on the paper type or the operating environment, vertical streaks
may appear on the printed paper. In this case, selecting [On] may solve the
problem.
If the printer produces sound during printing, selecting [On] may also reduce
the noise.
㻡㻤㻜㻌㻛㻌㻥㻣㻜