Insert Drawer n ("n" represents a number.)
<Cause> The drawer is not inserted.
Solution Insert the drawer.
Insert toner cartridge.
<Cause> The toner cartridge is not installed or installed improperly.
Solution
Install the toner cartridge properly.
"Toner Cartridge Replacement"
Key management file is corrupt or deleted.
<Cause> The file related to key management is broken.
Solution
Perform the following procedure.
1. 6HOHFW>1HWZRUN@ĺ>5HPRWH8,6HWWLQJV@ĺ>66/@XVLQJWKHFRQWUROSDQHOWKHQPDNHVXUHWKDW
[SSL] is set to [Off].
2. Restart the printer, and then regenerate the key and certificate and specify the settings for SSL
from the Remote UI.
"Security Settings"
3. Restart the printer.
Load paper.
<Cause> Paper of the size specified in the application is not loaded in the paper source (in all the
paper sources when [Paper Source] is set to [Auto] and in the specified paper source when the setting
is fixed).
Solution 1 Refill or load paper.
Solution 2
Press [
] ( : Feeder Selection), and then select other paper source for the same paper size or larger
paper size.
"[Select Feeder] Menu"
Not
enough
download memory.
<Auto
Error
Skip>
<Cause> The memory for registering overlay forms and custom characters ran out and overflowed.
Solution 1
Press [
] ( : Online) to continue printing. However, the overflowed data cannot be registered.
Solution 2
Perform the following procedure.
1. Perform a soft reset.
"Canceling the Process Currently Being Performed (Soft Reset)"
2. After the soft reset, either perform a hard reset or turn the printer back ON, increase memory
capacity and print again. (All data in the memory will be erased.)
"Canceling All the Jobs (Hard Reset)"
Not enough memory for PDF processing.
㻤㻥㻥㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
