<Cause> There is not enough memory to process a PDF file.
Solution
Perform the following procedure.
1. Perform a soft reset.
"Canceling the Process Currently Being Performed (Soft Reset)"
2. Decrease the size of the PDF file or divide it into multiple files, and then print again.
The PDF data may be printed properly by opening it from an application and using the printer
driver.
Not
enough
memory
for XPS
processing.
<Auto
Error
Skip>
<Cause> There is not enough memory for XPS processing.
Solution 1
Press [
] ( : Online), and continue printing. However, the data that generated the error will not be
printed correctly.
Solution 2
If images such as Progressive JPEG are handled inside the XPS, convert them to TIFF or Baseline JPEG
and then print.
Not
enough
spool
memory.
<Auto
Error
Skip>
<Cause> Because spool memory ran out, the printer cannot print.
Solution 1
Press [
] ( : Online) to continue printing. However, the page with which an error is occurring is not
printed.
Solution 2
Perform the following procedure.
1. Perform a soft reset.
"Canceling the Process Currently Being Performed (Soft Reset)"
2. Specify the paper size smaller, and then print again.
Solution 3
Perform the following procedure.
1. Perform a soft reset.
"Canceling the Process Currently Being Performed (Soft Reset)"
2. Set [Image Refinement] to [Off], and then print again.
"[Setup] Menu ([Quality] Options)"
Solution 4
If [2-Sided Printing] is set to [On], specify [Off], and then print again.
"[Setup] Menu ([Paper Source] Options)"
Solution 5
Change the setting for [Halftones], and then print again.
"[Setup] Menu ([Quality] Options)"
Not
enough
system
memory.
<Auto
Error
Skip>
<Cause> The work memory required for the printer process ran out while the system was processing
the data (mainly the graphics data and text data).
Solution 1
Press [
] ( : Online) to continue printing. However, the data with which an error is occurring is not
㻥㻜㻜㻌㻛㻌㻥㻣㻜
To Next Page
Loading...
