Cisco MDS 9000 Series Configuration Guide

7. Verify the pending zone configurations using the autozone --showpending command:
switch# autozone --showpending
Feature AutoZone : Enabled
zoneset name AUTOZONESET vsan 1
zone name AUTOZONE_JPG21190082_2 vsan 1
member pwwn 20:00:00:11:0d:97:00:01
member pwwn 20:01:00:11:0d:97:01:00
zone name AUTOZONE_JPG21190082_3 vsan 1
member pwwn 20:00:00:11:0d:97:00:00
member pwwn 20:01:00:11:0d:97:01:01
zone name AUTOZONE_JPG21190082_4 vsan 1
member pwwn 20:00:00:11:0d:97:00:01
member pwwn 20:01:00:11:0d:97:01:01
8. (Optional) You can execute Autozone manually for updating the zoning information each time a new
device is logged into the switch using the autozone --update command:
switch# autozone --update
Device with pwwn 10:00:00:de:fb:74:e8:31 is not registered with FC4-type Init or Target.
Hence, it will be ignored for AutoZone configuration.
Configuring zones for vsan 1
AUTOZONE_JPG21190082_1
AUTOZONE_JPG21190082_2
AUTOZONE_JPG21190082_3
AUTOZONE_JPG21190082_4
Configuring zoneset for vsan 1
Activating the zoneset. Please wait...
Configured zoneset AUTOZONESET for vsan 1 successfully.
9. Verify the zone configuration for the new devices using the autozone --show command:
switch# autozone --show
Feature AutoZone : Enabled
The possible zone/zoneset configuration with AutoZone feature for currently logged-in
devices are :
zoneset name AUTOZONESET vsan 1
zone name AUTOZONE_JPG21190082_1 vsan 1
member pwwn 20:00:00:11:0d:97:00:00
member pwwn 20:01:00:11:0d:97:01:00
zone name AUTOZONE_JPG21190082_2 vsan 1
member pwwn 20:00:00:11:0d:97:00:01
member pwwn 20:01:00:11:0d:97:01:00
zone name AUTOZONE_JPG21190082_3 vsan 1
member pwwn 20:00:00:11:0d:97:00:00
member pwwn 20:01:00:11:0d:97:01:01
zone name AUTOZONE_JPG21190082_4 vsan 1
member pwwn 20:00:00:11:0d:97:00:01
member pwwn 20:01:00:11:0d:97:01:01
Cisco MDS 9000 Series Fabric Configuration Guide, Release 8.x
52
Configuring and Managing Zones
Autozone Example Scenario

Cisco MDS 9000 Series Specifications

General

Category	Switch
Operating System	Cisco NX-OS
Ports	Varies by model
Protocols	Fibre Channel (FC), Fibre Channel over IP (FCIP), iSCSI
Redundancy	Redundant supervisors, power supplies, and fans
Management	Cisco Data Center Network Manager (DCNM), CLI, SNMP
Virtualization Support	VSANs (Virtual SANs)
Security Features	Fibre Channel Security Protocol (FC-SP)
Hot Swappable Components	power supplies, fans
Power Supply Options	AC and DC options available