CRE Technology GENSYS 2.0 - Page 3

A53 Z0 9 0020 L En Technical documentation
Chapter : Overview
3
Technical documentation history
Date
Version
Comments
Nov. 2008
A
Derived from GENSYS documentation. Starting point.
Jan. 2008
B
Correction and full explanation of several features.
Feb. 2008
C
Added menu references. Global revision by all the team.
Mar. 2009
D
Details added for the reset of alarms, faults, and data logging.
Details added for the semi auto mode.
July 2009
E
J1939 details added.
Modification of general wiring diagram.
Removal of USB connection.
Addition of Ethernet connection.
Sept. 2009
F
Firmware update using SD card added.
Chapter on GENSYS 1.0/GENSYS 2.0 compatibility added.
Extra information concerning analogue sensors.
Information concerning CEM compliance added.
Ethernet connection added and USB connection chapter updated.
Digital input parameter errors corrected.
Feb. 2010
G
Two phase/three phase system management added.
SD card archiving added.
Breaker management info added.
SD card flashing removed.
Start sequence.
July 2010
H
GENSYS 2.0 firmware v2.05
IP address can now be changed.
Support of Modbus TCP.
J1939 compatibility with Cummins QSX15G8
Automatic shutdown of the horn.
Corrections on PWM 500Hz documentation.
CANopen example changed.
April 2011
I
Enhanced semi-automatic mode description.
New chapter concerning optional power tank capacitor.
New: minimum wiring diagram.
Updated static paralleling diagram.
Updated maintenance cycles chapter.
Updated reference of digital input variables.
Updated custom logo size.
Updated CAN bus good practices.
Updated technical support contact.
Updated external automatic start module setup description.
Additional features starting from firmware v3.00:
CRE Config software compatibility.
Assisted manual mode.
Front panel button inhibition.
Firmware upgrade using SD card.
Generating an empty file template.
Import/Export/Delete TXT files on SD card.
Resetting factory parameters.
New methods to permanently store parameters in memory.