A53 Z0 9 0020 L En Technical documentation
Additional features starting from firmware v4.00:
Power plant up to 32 modules using CAN bus.
Support of FAT32 SDHC cards.
Automatic backup of new parameter values.
ASSISTED MANUAL mode activated by default.
Option 7: Enable/disable internal engine start sequence.
Interface with external start module without equation.
Fuel/water/oil filling without equation.
New menu organization.
Potential Alarm/Fault list.
Download of a CUSTOM language file.
Enhancements and modifications :
Update of schematics and graphs.
Maximal CT ratio value.
Maximum size of text file.
Available data space for SD card and internal FIFO loggers.
External power tank to be used only with a 12V battery.
Compatibility with RDM 2.0 remote display module.
GENSYS 2.0 CORE and GENSYS 2.0 LT dedicated chapters.
Chapter 10.3, table 22 : AVR Leroy Somer R450 and Stamford MX341.
Chapter 13 .8 BSM II cable reference removed (not useful).
Chapter 15.3.2: Add J1939 display page of unknown SPN/FMI.
Chapter 17.3.12: Add the reset maintenance cycle page.
Chapter 15.7.1 : Safely remove your SD card.
Chapter 17.4.3.2 : LCD backlight adjustment through “System/Display
properties” menu.
Chapter 20.2 Accessories : Add A40W2 cable.
Chapter 20.1: Add reference of all GENSYS 2.0 family modules.
New features supported by v4.03/v4.04:
Additional MODBUS support including:
Multiple TCP connections.
New function support (01, 02, 05, 0F).
Advanced rights management (read/write access).
Support of Modbus RTU over TCP in addition to
standard Modbus TCP protocol.
Chapter 17.3.9: configurable synchronization dwell timer
(E4108).
Updated wiring of standard CAN (DB9 connectors)
Table 7: Added frequency range of voltage measurements.
Chapter 15.3.2: Note on Cummins CPG / G Drive ECU firmwares.
To Next Page
Loading...
Need help?
General
