High Availability | 455
Power Status : AC
Voltage : ok
Serial Number : FX000017082
--More--
2. The cache boot feature requires at least the boot code versions in Table 21-5, "Boot Code
Requirements for Cache Boot," in High Availability. Use
show rpm and show linecard commands to
verify that you have the proper version.
If you do not have the proper boot code version, the system displays a message similar to Message 7 when
you attempt to select a cache boot image (see Select the Cache Boot Image). See Upgrading the Boot Code
in the Release Notes for instructions on upgrading boot code.
Select the Cache Boot Image
Select the FTOS image that you want to cache using the command upgrade system-image, as shown in the
example below. Dell Force10 recommends using the keyword
all with this command to avoid any
mis-matched configurations.
FTOS#upgrade system-image all A flash://FTOS-EF-7.8.1.0.bin
Current cache boot information in the system:
=============================================
Type A B
---------------------------------------------------------
CP invalid invalid
RP1 invalid[b][n] invalid
RP2 invalid invalid
linecard 0 invalid invalid
linecard 1 is not present.
linecard 2 is not present.
linecard 3 is not present.
Table 21-5. Boot Code Requirements for Cache Boot
Component Boot Code
E-Series TeraScale RPM 2.4.2.1
E-Series TeraScale Line Card 2.3.2.1
E-Series ExaScale RPM 2.5.0.3
E-Series ExaScale Line Card 2.9.0.5
C-Series RPM 2.7.1.1
C-Series Line Card 2.6.0.1
Message 7 Boot Code Upgrade Required for Cache Boot Error
% Error: linecard 0 doesn't have cache boot aware bootCode.
Note: The cache boot feature is not enabled by default; you must copy the running configuration to the
startup configuration (copy running-config startup-config) after selecting a cache boot image in order to
enable it.
To Next Page
Loading...
