OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
1. Enter the parameters defining a Radial-To procedure: waypoint identifier, inbound course (radial) and
distance.
2. Access the ACT RTE x LEGS or RTE x LEGS page(s) by pressing NEW RADIAL-TO at LSK 6L. The
corresponding RTE x LEGS page(s) is accessed with the Radial-To information in the scratchpad.
Press the LSK (1L, 2L, 3L, 4L or 5L) where the segment is to be inserted.
NOTES:
a) If the reference point is not part of the selected route, then the segment is inserted between the waypoint
corresponding to the LSK pressed and the following waypoint.
b) If the reference waypoint belongs to the route, the route is modified as follows:
1- The insertion waypoint is two places ahead. The Radial-To segment replaces the segment between the
insertion waypoint and the next.
2- The insertion waypoint is one waypoint ahead of the reference waypoint. Radial-To segment replaces the
segment between the insertion and the reference waypoints.
3- The insertion waypoint is the reference waypoint. The following segments replace the segment between
the preceding and the reference segment. The segment created between the preceding and the Radial-To
entry waypoints is followed by the Radial-To segment.
4- The insertion waypoint follows the reference waypoint. This is an abnormal situation, where the Radial-To
flight path is flown back and forth at the reference waypoint. A discontinuity is created at the next waypoint.
5- The insertion waypoint is more than one waypoint passed the reference waypoint. The Radial-To segment
is introduced as described for a reference waypoint that does not belong to the route. However the route
will be comprised of a closed loop section.
ACT RTE 1 LEGS 2/4
299
o
39.6NM
CAFTA
298
o
154NM
YZP
307
o
86.7NM
MOCA1
306
o
165NM
BKA
282
o
197NM
KILLA
<RTE 2 KJFK LEGS ETA>
YUL076
10.0
R
Page 5-7
August 17, 2010
To Next Page
Loading...