OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
ROUTE SELECTION FROM THE LIST OF CUSTOM ROUTES
With the ACT or MOD RTE 1/X page displayed:
Display the custom routes by pressing <CO ROUTES> (LSK 4R).
SELECT CO ROUTE 1/1
KSEAPANC KSEAPANC1
KSEAPANC2
LOAD
>DIRECT
<ROUTE
Custom routes are displayed left to right, sorted by origin identifier.
NOTE: If the display of the CO ROUTE is configured to ORIG_DEST, the entry of an ORIGIN or both
ORIGIN and DEST identifiers on RTE x 1/X page will reduce the custom routes list, when on
ground, to those specified in the ORIGIN or ORIGIN and DEST fields. When airborne, all custom
routes are displayed. If CO ROUTE is configured to ALL, every CO ROUTE in the custom database
will be displayed.
1. Display the desired route by pressing [NEXT] or [PREV] as often as required.
2. Select route identifier by pressing the appropriate LSK.
3. Select the direction in which the route is loaded by toggling DIRECT/INVERSE using LSK 5L.
4. The RTE 1/X page is re-displayed. Verify the ORIGIN and DEST identifiers.
5. Accept the new active route by pressing [EXEC].
When airborne, selecting a custom route will replace the destination with the selected custom route
destination and will insert a discontinuity after the active waypoint followed by the selected custom route
waypoints. If a procedure (for e.g. STAR or Approach) is part of the flight plan, the whole procedure is
replaced by the selected custom route.
Page 3-10
August 17, 2010
To Next Page
Loading...