Esterline CMA-9000 - Cancelling any Procedure or Route Modification; Initial Leg; Verifying Active Route Legs by Course and Distance

OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
VERIFYING ACTIVE ROUTE LEGS BY COURSE AND DISTANCE
Display the MOD RTE x LEGS 1/X page by pressing [LEGS].
1. Verify the course and distance of all route legs.
2. Display all route legs in sequence by pressing [NEXT] as often as required.
3. Return to the MOD RTE x LEGS 1/X page by pressing [LEGS] or [PREV] as required.
4. Make the route active by pressing [EXEC].
The "MOD" status in the title line changes to "ACT", the ERASE prompt disappears and the EXEC
annunciator extinguishes.
INITIAL LEG
Following the waypoint of a route, navigation and guidance is computed initially for the leg from present position
direct to the first waypoint. On takeoff, the FMS automatically re-computes a Direct-To to the first waypoint.
If a runway and SID are selected and the first leg is not a Direct-To leg, navigation and guidance is computed
initially from the runway threshold to the first waypoint. On take-off, the FMS automatically re-computes the
initial leg using the present position as the start of the leg.
To navigate a different first leg, follow any of the route modification procedures described in Section 5.
CANCELLING ANY PROCEDURE OR ROUTE MODIFICATION
During any procedure which involves a modification to the active route, an ERASE prompt is displayed at
LSK 6L. Prior to EXECuting the procedure, it can be cancelled and all route modifications deleted by pressing
<ERASE> (LSK 6L).
1R
2R
3R
4R
5R
MOD RTE 1 LEGS 2/4
299
o
39.6NM
CAFTA
298
o
154NM
YZP
307
o
86.7NM
MOCA1
306
o
165NM
BKA
282
o
197NM
KILLA
<ERASE LEGS ETA>
1L
2L
3L
4L
5L
6L
6R
Page 3-16
August 17, 2010
DRAFT