OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
NAVIGATION RADIOS (ADF RADIO)
The FMS supports the following ADF Radio in the frequency range and channel spacing specified below:
RADIO MODEL FREQUENCY RANGE CHANNEL SPACING
RC ADF-4000 190.0 to 1799.5 KHz 0.5 KHz
Figure 13-1 ADF Radio Model Frequency Range and Channel Spacing
NOTE: The FMS does not accept out of range values. An error message will appear in the scratchpad if invalid
entries are made by the user. If the ADF Frequency Source Selection discrete is set then entries
made will generate an error message "RADIO TUNING DISABLED” to inform the pilot that he may no
longer tune this radio from the FMS.
NAVIGATION RADIOS (ADF Page 1/2)
This page allows the pilot to control the operation of 2 ADF units.
NOTE: Tuning commands will only be accepted if the FMS is enabled for navigation radio tuning control (e.g.:
when interfaced with an external Radio Management Panel).
NOTE: The page title may change from 1/2 to 1/1 once airborne if configured accordingly.
Display the first ADF RADIO page from the horizontal configuration by pressing [RADIO], <ADF#>.
NOTE: The ADF ident suffix "x" (e.g. ADF, ADF1...) and the side (left or right) where the ADF units appear are
depending on the installation configuration. The tables below provide examples.
ADF1 [1L]: Display and modify active/standby preset number and frequency of the ADF1 radio. Selecting
LSK_1L when the scratchpad is empty will toggle the standby and the active preset/frequency.
ADF2 [1R]: Display and modify active/standby preset number and frequency of the ADF2 radio. Selecting
LSK_1R when the scratchpad is empty will toggle the standby and the active preset/frequency.
ADF 1/2
ADF1 ADF2
b1234.5 01 04 407.0b
1780.6 -- -- 333.5
MODE MODE
>ADF ANT<
BFO BFO
>OFF ON<
REL-BRG MAG-BRG
>231
o
<
<RADIO LIBRARY>
Page 13-15
August 17, 2010
To Next Page
Loading...