OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
DME [4R]: Display of the distance and station identifier received from the tuned DME that is paired with the tuned
MLS (1R). When the tuned DME is paired with the tuned ILS (1L), this data field will be blank. No manual entries
are permitted.
STATUS [5R]: Display of the tuning status of the MLS receiver. Pressing this softkey selects the next option.
The possible values are ACTIVE and STANDBY. If the ILS STATUS (5L) is set to ACTIVE, the MLS STATUS
(5R) will automatically revert to STANDBY.
NAVIGATION RADIOS (ILS/MLS Page 2/2)
This page allows the pilot to control the operation of up to 2 ILS/MLS radios.
Display the second ILS/MLS page from the horizontal configuration by pressing [RADIO], <ILS>, [NEXT].
NOTE: The page title will be ‘ILS’ instead of ‘ILS/MLS’ if no MLS receiver is configured. No associated MLS
symbology will be displayed under these circumstances.
ILS MODE [1L]: Display of the tuning mode of the ILS receiver. Pressing this softkey selects the next option.
The possible values are AUTOMATIC and MANUAL.
MLS MODE [1R]: Display of the tuning mode of the MLS receiver. Pressing this softkey selects the next option.
The possible values are AUTOMATIC and MANUAL.
NOTE: Selection of an ILS/MLS tuning mode will only be accepted if the FMS is enabled for navigation radio
tuning control (e.g.: when interfaced with an external Radio Management Panel). If the FMS is not
enabled for navigation radio tuning control, the ILS/MLS tuning mode automatically reverts to MANUAL.
RADIO [6L]: Access to the RADIO top level page where the ILS/MLS is located.
ILS/MLS 2/2
ILS MODE MLS MODE
>AUTOMATIC MANUAL<
<RADIO
Page 13-14
August 17, 2010
To Next Page
Loading...