OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
VHF1 TEST [5L]: Toggles VHF1 test status & results. Toggle options for test status are READY, CONFIRM?,
STARTED. Pressing LSK the first time causes CONFIRM? to appear the second press initiates the tests. Test
result is: PASS or FAIL or TIMEOUT.
VHF2 TEST [5R]: Same as above, but referencing VHF2 instead of VHF1.
NOTE: The VHF1/2 TEST prompts may no longer be displayed once airborne if configured accordingly.
RADIO [6L]: Access to the RADIO top level page where the VHF is located.
COMMUNICATION RADIOS (HF)
The FMS supports the following HF Radio in the frequency ranges specified below:
RADIO
MODEL
FREQUENCY
RANGE
CHANNEL
SPACING
KHF-1050 2.0000 MHz – 29.9999 MHz 100 Hz
Figure 13-3 HF Radio Model, Frequency Range, Channel Spacing and Modulation
COMMUNICATION RADIOS (HF RADIO Page 1/1)
This page allows the pilot to control the operation of 2 HF radios.
NOTE: Tuning commands will only be accepted if the FMS is enabled for communication radio tuning control
(e.g.: when interfaced with an external Radio Management Panel).
Display the first HF 1/2 page from the horizontal configuration by pressing [RADIO], [NEXT].
KHF-1050 HF radio page display:
HF 1/1
HF1 HF2
Ú
11.2790 04 21 8.8910 Ú
8.8910 05
22 2.9710
MODE MODE
>AM < USB
<RADIO LIBRARY>
Page 13-19
August 17, 2010