OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
WAYPOINT DELETION
A. BY CLOSE-UP METHOD
1. Display the waypoint to be deleted by pressing [LEGS] and [NEXT] or [PREV] as required.
2. Copy the waypoint identifier following the one to be deleted into the scratchpad by pressing the
appropriate LSK.
3. Move the waypoint to the location of the waypoint to be deleted by pressing the appropriate LSK.
The selected waypoint is deleted from the route.
4. Verify the entry by checking the course and distance of the previous and next legs.
5. Make the modified route active by pressing [EXEC].
NOTE: In this case, a ROUTE DISCONTINUITY is not created.
"Close up" is the simplest method to delete a number of consecutive waypoints, but this can also be performed
by a series of [CLR] key operations.
B. BY CLEAR KEY
1. Start the deletion by pressing [CLR].
"DELETE" message is displayed in the scratchpad.
NOTE: "DELETE" is displayed only when the scratchpad is empty.
2. Display the desired waypoint by pressing [LEGS], and [NEXT] or [PREV] as required.
3. Delete the selected waypoint by pressing the appropriate LSK.
A "ROUTE DISCONTINUITY" is inserted in place of the deleted waypoint. Any holding pattern associated with
the deleted waypoint will also be deleted.
4. Verify the entry by checking course and distance of the previous and next legs.
5. Make the modified route active by pressing [EXEC].
Page 5-9
August 17, 2010
To Next Page
Loading...