OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
B. DIRECT-TO AN OFF-ROUTE WAYPOINT
1. Key in the off-route waypoint identifier.
2. Display the ACT RTE x LEGS 1/X page by pressing [LEGS].
3. Move the waypoint identifier to the TO WPT field by pressing LSK 1L.
"ACT" status on the title line is replaced by "MOD". The direct course and distance from aircraft present
position to the TO waypoint is displayed.
"THEN" and "ROUTE DISCONTINUITY" lines are inserted immediately after the new TO waypoint.
4. Verify the inbound course and distance of the leg to the TO WPT.
5. Make the direct-to leg active by pressing [EXEC].
6. Close up the route discontinuity as defined by the ATC clearance.
NOTE: This procedure may result in the creation of an “orphan” waypoint. That is, an isolated waypoint with no
connection to the rest of the flight plan.
C. DIRECT-TO A WAYPOINT IN THE INACTIVE ROUTE
1. Display the ACT RTE x LEGS 1/X page by pressing [LEGS].
2. Display the inactive RTE 2 x LEGS 1/X page xxx by pressing LSK 6L.
3. Key in, or copy the waypoint identifier into the scratchpad by pressing the appropriate LSK.
4. The waypoint identifier is displayed in the scratchpad.
5. Move the waypoint identifier to the TO WPT field by pressing LSK 1L.
The direct course and distance from aircraft present position to the TO waypoint is displayed.
"THEN" and "ROUTE DISCONTINUITY" lines are inserted immediately after the new TO waypoint.
6. Verify the inbound course and distance of the leg to the TO WPT.
Information on any other page can be verified prior to making the direct-to leg active.
7. Insert the direct-to leg in the inactive route by pressing <CONFIRM>.
Page 9-3
August 17, 2010
To Next Page
Loading...