Esterline CMA-9000 - Inserting a Radial-To Segment; Navigation Database Waypoints

OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
5. Make the modified route active by pressing [EXEC].
The waypoint name is automatically named "WPT" followed by a sequence number (e.g. WPT01).
Alternatively, the waypoint name can be automatically named using the latitude and longitude degree
components (e.g. N60W120). This option is selectable through configuration pages.
NOTE: The system allows maximum 99 temporary waypoints in a flight plan.
E. NAVIGATION DATABASE WAYPOINTS
1. Key the new waypoint identifier into the scratchpad.
2. Display the desired insert location in the route by pressing [LEGS] and [NEXT] or [PREV] as required.
3. Move the waypoint to the desired place in the route by pressing the appropriate LSK.
If the identifier is not found in the navigation database, the message "!NOT IN DATABASE" will be displayed in
the scratchpad.
4. Verify the waypoint entry by checking course and distance of the previous and next legs.
5. Make the modified route active by pressing [EXEC].
INSERTING A RADIAL-TO SEGMENT
A Radial-To segment is first defined in the RADIAL-TO, which is accessed by typing /R in the scratchpad and
pressing the LSK corresponding to the waypoint on which the operator wants to define a Radial-To procedure.
1R
2R
3R
4R
5R
RTE 1 RADIAL-TO 1/1
FIX
YUL
INBD CRS
016
o
DISTANCE
10.0NM
<NEW RADIAL-TO
1L
2L
3L
4L
5L
6L
6R
Page 5-6
August 17, 2010
DRAFT