Esterline CMA-9000 - STANDARD INSTRUMENT DEPARTURE (SID) SELECTION

OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
STANDARD INSTRUMENT DEPARTURE (SID) SELECTION
This procedure is based on the SID and SID transition depicted in Figure 4-1 and assumes that only these
portions of the departure are to be loaded at this time.
Display the DEP/ARR INDEX 1/1 page by pressing:
• [DEP/ARR] (if on ground).
• [DEP/ARR] (if airborne and midway point of active route not reached yet).
• From ARRIVALS 1/1 page.
• From DEPARTURES 1/1.
NOTE: If the FMS is configured for two routes (RTE 1 and RTE 2), the origin and destination of the inactive
route are also displayed. The active route information is displayed in white text. The inactive route
origin and destination airport codes are displayed in cyan.
1. Display the DEPARTURES 1/X page by pressing the DEP prompt at LSK 1L.
The DEPARTURES 1/X page is displayed, with the origin airport ICAO code included in the title line. Lists of
SIDs and runways for that airport are displayed
1R
2R
3R
4R
5R
DEP/ARR INDEX 1/1
ACT RTE 1
<DEP KSEA ARR>
PANC ARR>
RTE 2
<DEP KSEA ARR>
PANC ARR>
1L
2L
3L
4L
5L
6L
6R
KBFI DEPARTURES 1/1
SIDS RTE 1 RUNWAYS
LACRES 13R
QUIET1 31L
<DEP/ARR ROUTE>
1R
2R
3R
4R
5R
6R
1L
2L
3L
4L
5L
6L
Page 4-4
August 17, 2010
DRAFT