OPERATOR’S MANUAL
CMA-9000 FLIGHT MANAGEMENT SYSTEM
HOLDING PATTERN AT AN OFF-ROUTE WAYPOINT
Key a valid off-route waypoint identifier followed by /H into the scratchpad (e.g.: KILLA/H).
NOTE: If the waypoint is not in the navigation database, the temporary waypoint should be created and inserted
in the desired location in the route (as described in Section 5) before defining the holding pattern.
1. Display the desired location in the route by pressing [LEGS] and [NEXT] as required.
2. Move the waypoint entry to the desired location by pressing the appropriate LSK.
The MOD HOLD page is displayed. Modify the holding pattern parameters as required, following the manual
entry procedure described previously.
3. Verify the holding pattern parameters, and arm the hold by pressing [EXEC].
NOTE: If the off-route waypoint is made the TO WPT, EXECuting the holding pattern ALSO results in direct-to
navigation to the holding waypoint without an intercept course. If an intercept course is required,
return to the LEGS page and setup the intercept course prior to pressing EXEC.
MOD RTE 1 HOLD 1/1
FIX SPD/TGT ALT
KILLA 220/ 5000A
TURN DIR FIX ETA
>RIGHT 1425.5Z
INBD CRS HOLD TIME
050° 01+45.0
LEG TIME/DIS BEST SPD
1.0MIN/--.-NM 208KT
EXIT TYPE STATUS
MANUAL INACTIVE
<ERASE
Page 10-7
August 17, 2010
To Next Page
Loading...